WIDIA - Полный каталог инструмента - 2017
для размещения заказа - zakaz@widiahanita.ru
Indexable Drills
Application Data • Top Cut 4™
Top Cut 4 • Stainless Steel • 2 x D/3 x D • Speed Chart • Metric
Top Cut 4
Insert Size A
Recommended Cutting Speed by Diameter (m/min)
Insert Size B
Insert Size C
Insert Size D
TCF040203AC
TCF040204AP
12,00–13,99mm
TCF060203BC
TCF050204BP
14,00–18,99mm
TCF070304CC
TCF070306CP
19,00–23,99mm
TCF090305DC
TCF080308DP
24,00–29,99mm
Material
Pocket
Group Condition Seat Geometry Grade min Start max min Start max min Start max min Start
P V36 WU40PH
S 120 140 160 140 160 230 150 170 240 150 170
C V36 WU40PH
1U
P V36 WU40PH
110 120 140 130 150 210 130 160 210 130 160
C V36 WU40PH
P V36 WU40PH
I 90 100 120 130 150 200 130 160 200 130 160
C V36 WU40PH
P V36 WU40PH
S 120 140 160 140 160 200 150 170 210 150 170
C V36 WU40PH
M2
U
P V36 WU40PH
110 120 140 130 150 180 130 160 200 130 160
C V36 WU40PH
P V36 WU40PH
I 90 100 120 120 140 170 130 150 180 130 150
C V36 WU40PH
P V36 WU40PH
S 110 120 140 130 150 180 140 160 200 140 160
C V36 WU40PH
3U
P V36 WU40PH
90 110 120 120 130 160 130 140 180 130 140
C V36 WU40PH
P V36 WU40PH
I 80 100 110 100 120 150 110 130 160 110 130
C V36 WU40PH
NOTE: For 4 x D, it is highly recommended to start with feed and speed values reduced by 10% less than above recommendations.
For 5 x D, diameter range 12–23,99mm (insert sizes A to C), it is highly recommended to start with feed and speed values reduced by 20% less than
above recommendations.
For 5 x D, diameter range 24–68mm (insert sizes D to H), it is highly recommended to start with feed and speed values reduced by 15% less than
above recommendations.
For 4 x D and 5 x D, it is recommended to reduce the feed rate during entry and exit by 30–50%.
max
240
210
200
210
200
180
200
180
160
Condition: S = stable conditions,
U = unstable cutting conditions,
I = interrupted cutting conditions
Pocket Seat: P = periphery insert,
C = centre insert
zakaz@widiahanita.ru
www.widiahanita.ru
V29