WIDIA - Полный каталог инструмента - 2017
для размещения заказа - zakaz@widiahanita.ru
Indexable Drills
Application Data • Top Cut 4™
Top Cut 4 • Cast Iron • 2 x D/3 x D • Speed Chart • Metric
Top Cut 4
Insert Size A
Recommended Cutting Speed by Diameter (m/min)
Insert Size B
Insert Size C
Insert Size D
TCF040203AC
TCF040204AP
12,00–13,99mm
TCF060203BC
TCF050204BP
14,00–18,99mm
TCF070304CC
TCF070306CP
19,00–23,99mm
TCF090305DC
TCF080308DP
24,00–29,99mm
Material
Pocket
Group Condition Seat Geometry Grade min Start max min Start max min Start max min Start
P V34 WPK10CH
S 120 140 180 140 170 250 150 180 260 160 200
C V34 WU25CH
1U
P V34 WU25CH
110 120 160 130 160 240 140 170 250 150 180
C V34 WU40PH
P V34 WU40PH
I 100 110 140 120 150 230 130 160 240 140 170
C V34 WU40PH
P V34 WPK10CH
S 120 140 180 130 160 240 140 180 250 150 180
C V34 WU25CH
K2
U
P V34 WU25CH
110 120 160 120 150 230 130 160 240 140 160
C V34 WU40PH
P V34 WU40PH
I 100 110 140 120 150 220 130 160 240 140 160
C V34 WU40PH
P V34 WPK10CH
S 120 140 160 130 160 240 140 170 240 150 170
C V34 WU25CH
3U
P V34 WU25CH
110 120 140 120 150 230 130 160 230 140 160
C V34 WU40PH
P V34 WU40PH
I 90 100 120 120 150 230 130 160 230 140 160
C V34 WU40PH
NOTE: For 4 x D, it is highly recommended to start with feed and speed values reduced by 10% less than above recommendations.
For 5 x D, diameter range 12–23,99mm (insert sizes A to C), it is highly recommended to start with feed and speed values reduced by 20% less than
above recommendations.
For 5 x D, diameter range 24–68mm (insert sizes D to H), it is highly recommended to start with feed and speed values reduced by 15% less than
above recommendations.
For 4 x D and 5 x D, it is recommended to reduce the feed rate during entry and exit by 30–50%.
max
280
260
260
260
250
250
250
240
220
Condition: S = stable conditions,
U = unstable cutting conditions,
I = interrupted cutting conditions
Pocket Seat: P = periphery insert,
C = centre insert
zakaz@widiahanita.ru
www.widiahanita.ru
V33