WIDIA - Полный каталог инструмента - 2017
ProGroove™
Feed Values for Grooving Inserts
для размещения заказа - zakaz@widiahanita.ru
PGU
For grooving and parting operations, universal use.
Positive chipbreaker groove for light cutting action.
Right-hand and left-hand styles with 6° front angle.
left-hand
neutral
right-hand
PGM
width of cut [mm]
1 Recommended Starting Feed
neutral
PGS
For grooving and parting, also capable of copy
and straight turning as well as chamfering. With
additional chip forming element for good chip
control with varying depths of cut.
width of cut [mm]
1 Recommended Starting Feed
left-hand
neutral
right-hand
For low-bur parting with straight flanks and smooth surface
finishes. All inserts are recommended for parting and
grooving slender workpieces, part diameter <32mm, and
thin-wall tubes.
PGR
width of cut [mm]
1 Recommended Starting Feed
Full round inserts for profiling, grooving, and
copy turning. Very good chip control for broad
general use. Accurate, reproducible cutting
edge positioning.
LG System • 0 and 1
01
E94
width of cut [mm]
1 Recommended Starting Feed
…0
Inserts with wide range of applications in grooving and
deep grooving. With additional chip control element for
good chip control, even with varying widths of cut.
…1
Inserts with wide range of uses in grooving and
deep grooving of short chipping materials.
zakaz@widiahanita.ru
www.widiahanita.ru
width of cut [mm]
1 Recommended Starting Feed